HELP what is bootload.hex for in upgrade
Printed from: Neuros Forums
Topic URL: http://www.neurosaudio.com/community/forum/topic.asp?TOPIC_ID=6983
Printed on: 01/04/2007
Topic:
Topic author: patch
Subject: HELP what is bootload.hex for in upgrade I tried to use the firmware up grade on my recorder (I know Dumb and not needed) but hine sight is always 20/20. When I did it i only copied the main.hex file to the cf card. all reported as good but now the recorder comes up with 'no program' on the tv and a blank screen
Replies:
Posted on: 02/17/2006 08:44:48 AM
Message:
I checked the zip file and there is a file bootload.hex which I had not copied to the cf card. Is this my error? can it be fixed? does anyone know the bootload.hex and what it is for.
I have redone this with the bootload.hex file and the main.hex but still no program and a blank screen
HELP please anyone. I promise not to mess with anything again
Patrick
Patrick
Reply author: Derek
Replied on: 02/17/2006 11:29:11 AM
Message:
do you know what version of firmware you started with? I have the most current firmware if you want to try that. There may be some others who can help you more, i have not messed with the recorder firmware that much.
oh, and you dont need the bootload file...only the main.hex
When I was a kid my mom used to tell me that curiosity killed the cat...What she forgot to tell me was that it also discovered the cat, invented the lightbulb, and forged the Neuros
Reply author: patch
Replied on: 02/19/2006 06:07:53 AM
Message:
Thanks for the reply but as I said the screen mow comes up with 'no program' 'version 1.03'
The manual just refers to the main.hex file which is the one I used but the file notes (which I didn't read until i had a problem) refer to using the bootload file first then using the main.hex file to upgrade. Without knowing for sure I am guessing the bootlaod.hex must make some sort of back of the op program.
What I need now is to either reverse eng the damage or get a copy of the op program that I can use to upgrade the recorder. Maybe is someone has a bootlaod.hex with the program backedup?
At present I have an expensive CF/SD card reader
Patrick
Reply author: Derek
Replied on: 02/19/2006 1:05:35 PM
Message:
im sorry, i just noticed that this was posted in the recorder 1 forum, and not the recorder 2 forum. I think you did need the bootload file for the recorder 1.......
ok, did you buy your recorder off of woot? if you bought if off of woot i have a fix for you. if you bought it later, i still think we can get you up and running.
im going to send you an email with a read me file and a main.hex file that should restart your recorder with the older software, from there we should be able to upgrade back to where you want to be.
When I was a kid my mom used to tell me that curiosity killed the cat...What she forgot to tell me was that it also discovered the cat, invented the lightbulb, and forged the Neuros
Neuros Forums : http://www.neurosaudio.com/community/forum/
© Copyright ©2002-05 Neuros Technology International, LLC all rights reserved.