Neuros Forums

Remote Code Protocol

Printed from: Neuros Forums
Topic URL: http://www.neurosaudio.com/community/forum/topic.asp?TOPIC_ID=7096
Printed on: 03/24/2006

Topic:

Topic author: claydubois(at)bellsouth.net
Subject: Remote Code Protocol
Posted on: 03/20/2006 12:57:12 PM
Message:

I noticed a while back Joe posted the command code for the remote. I have a project I am working on where I use and embedded controller board to act as the remote. However, there are numerous IR protocols out there for sending remote signals. Which protocol does the Recorder use? Is there a datasheet on the IR transmitter chip available where I can look up this protocol? Thanks.

Replies:

Reply author: Ex-Navy
Replied on: 03/20/2006 2:32:25 PM
Message:

You can find them at www.olson-engineering.com under the Neuros button.

quote:
Originally posted by claydubois(at)bellsouth.net

I noticed a while back Joe posted the command code for the remote. I have a project I am working on where I use and embedded controller board to act as the remote. However, there are numerous IR protocols out there for sending remote signals. Which protocol does the Recorder use? Is there a datasheet on the IR transmitter chip available where I can look up this protocol? Thanks.

Ex-Navy

Neuros Forums : http://www.neurosaudio.com/community/forum/

Close Window