|
Title: Freeze after upgrading to 3.20-0.18 Post by: cricket on October 12, 2006, 01:34:50 PM After battling to find a SD card that I could upgrade the firmware with I did finally have success with a viking card. Upgrade went off without a hitch, however after the upgrade... pulling the battery and resetting the remote (064) I am now unable to recognize the SD card I upgraded with? If I reload the OSD with the SD in it, it hangs when the mem stick drivers are loading. If I wait until the OSD is up and then insert the SD card it freezes completely and requires a reload. :P
I am running the 3.20-0.18 firmware. Title: Re: Freeze after upgrading to 3.20-0.18 Post by: cricket on October 15, 2006, 04:34:27 PM Same behavior after upgrading to 3.20.-0.19 :'(
Title: Re: Freeze after upgrading to 3.20-0.18 Post by: kelly on October 16, 2006, 04:57:23 AM I also use SD card to update to 3.20-0.18 and 3.20-0.19,but OSD can recognize the SD card.
Do you means that after you finish updating to 3.20-0.19,then do nothing,after OSD reboot,SD card can't recognize even replug in SD card? Title: Re: Freeze after upgrading to 3.20-0.18 Post by: cricket on October 18, 2006, 06:40:23 AM Correct, after I upgraded I was unable to use the SD card. The system locks up. Yesterday I found some CF cards, this is the only media I have been able to boot with it inserted, successfully mount, remove and mount again without the OSD locking/freezing up. Unfortunately I cannot read anything on the CF card? Occasionally I was able to boot, mount CF, and then for some reason I was able to see and use the Viking SD card??
USB does nothing but crash the OSD completely. I would love to test some other stuff, like maybe even record but since media detection is so sketchy I really cant do anything with this device. Am I the only one having these problems? frustrated! |