Neuros Technology Forums

Sorry, just to check. You mean:
1. Your OSD is runing 3.20-0.20 version and you can read the version number from GUI on TV?
2. OSD can boot up normally, but always  reboot when displaying 'Loading mpeg_g7xx codec' every time?
3. OSD reboot even if you do nothing?

Thanks

No, it is not one USB interface, it is 14-dip JATG interface.

More important, you need one JTAG adapter  to program.

Now the remote jsut is sample.

Please try reprogram your remote controller again. Following below steps:

Step1: Please check battery has been placed in your Remote Controller correctly. This can be sure per LED flicker when press buttons.
Step2: Holding the Remote Controller 'set' button and press 'NTSC/PAL' button, you can see the LED light red.
Step3: Entering the number 0 and 6 and 4

At present, you can't exit via keyboard.
It seems your remote controller can't work completely. Didn't the LED flicker when press LEFT button? It look like the battery didn't be mounted in remote controller.

Would you like to recopy the file and try again?

yanvrno,
I guess you need reprogram Remote Controller.
Please follow
http://forums.neurostechnology.com/smf/index.php?topic=7462.0

cipher17,

Please try below steps:
1. Remove battery and plug in OSD power without battery Check if Remote Controller work well, if not, please do,
2.Pull off the OSD power, Connect Serial Interface to PC, open terminal and set bitrate to 115200, and then plug in OSD power without battery again
3.You can see information from terminal, and when OSD enter the Main Menu(File browser, Recorder...), Please press PC keyboard 'x' key (lowercase), OSD will display windows with About/System reboot
4.Please choose 'About' option, press PC keyboard 'Enter' key when cursor on the 'About' option. You can see Version information, Please give me the Version number.

If you set bitrate to 115200bps, the serial communicate should work well. Or could you try other PC?

If your Gamma OSD Remote Controller can't work. Please do as following.
First, reprogram the Remote Controller, follow the steps:
Step1: Please check battery has been placed in your Remote Controller correctly. This can be sure per LED flicker when press buttons.
Step2: Holding the Remote Controller 'set' button and press 'NTSC/PAL' button, you can see the LED light red.
Step3: Entering the number 0 and 6 and 4
After step1 and step2, Remote Controller finished reprogram. And at this time, Remote Control should can work.

If after step1 and step2, Remote Controller still can't work. So OSD Remote control HW might need a reset. To do so, please follow these steps,
Step4:  Disconnect OSD power;
Step5: Open OSD housing;
Step6:  Remove the on-board battery (or just put a piece of paper between the lever and the battery)
Step7:  Plug in OSD power; 5. Install back the battery (or just pull off the paper).
Step8:  Disconnect OSD power and put back the housing.

Here are the OSD Power consume data:
No power but battery: 3.3 uW
Power on but no video: about 1.3 W
Power on and have video: about 1.75 W
Recording: about 1.65 W
Playing: about 1.4 W